Stationary Mixer
THE RIGHT CHOICE FOR DIFFICULT JOBS.
The London® Stationary Mixer (8.5 cubic yard capacity) is the ideal choice for large, difficult on-site construction jobs such as tunnels, bridges, piers, mining and other super-duty applications.
Engineered for maximum productivity, the Stationary Mixer is unsurpassed for quality, performance and reliability.
Just like our truck-mounted mixers, the Stationary Mixer is manufactured for severe duty conditions, and features high manganese, low carbon steel drum shell that’s 100% welded inside and out, with 14” LONDOX 220 blades, solid wire welded seams and a solid steel drum track. And the electro-hydraulic mix and discharge controls are easy to operate.
Specifications:
MIXER
8.5 Cubic Yard Mixing Capacity
DRUM
| 1/4″ spun drumhead with 48″ inside reinforcing plate |
| 1/4″ LONDOX 220 wear-resistant (high manganese, low carbon) steel drum shell welded 100% inside and out |
| 1/4″ LONDOX 220 blades with hard surfaced lips and solid wire welded seams |
| Solid steel drum track machined inside taper and out square 43″ discharge opening |
| Auxiliary surge fins |
| 16″ X 22.5″ bolt on oval inspection hatch. |
FRONT PEDESTAL
| Fully enclosed Cor Ten “A” front pedestal incorporating a 15-gallon easy clean hydraulic oil reservoir |
| Flared lower front and rear flanges to distribute load |
REAR PEDESTAL
| Easy-to-clean enclosed rear pedestal with service access to the drum rolls and standard “Knee brace” |
| Pedestals constructed of CorTen”A” corrosion resistant steel |
| Fully welded swivel support integrated through pedestal frame |
BASE FRAME
8” X 3” X 1/4” HSS main rails and crossmembers, full length of assembly and 34” wide
TRANSMISSION
| Model ZF P7300 planetary direct drive |
| 144.3:1 reduction |
| 53,000 ft.lb. output torque capacity |
| Mounted to machined drum flange by 24 grade 8 bolts and to machined pedestal deck pads by 6 grade 8 bolts |
HYDROSTATIC
| Eaton heavy-duty 4.6 cubic inch variable displacement piston pump with built-in 5500 psi relief valve |
| Eaton heavy-duty 4.6 cubic inch displacement motor |
| Speed and direction of the drum rotation controlled from the cab and on the rear pendant |
| 10 micron suction filter |
| Heavy-duty front-mounted oil cooler with guard |
ELECTRIC MOTOR
60 H.P. 480v 3 phase motor (magnetic switch and Starter not included)
DRUM ROLLERS
| CM1035 alloy steel drum roller with tapered roller bearings |
| Double-sealed and centre shaft lubrication |
| Roller-surfaced hardened to Rockwell C46 |
| Full width rear drum roll guard |
CHARGE HOPPER
| 38″ X 30″ top opening |
| 19″ minimum throat dimension |
CONTROLS
| Electro-hydraulic mix-discharge control with 20′ quick disconnect cable |
| Drum speed and direction controlled from 0 -12 RPM |
PAINTING
| Mixer and components shot blasted prior to prime painting |
| All components painted prior to assembly |
| Top coat one color Sherwin-Williams 2-part polyurethane |